<div dir="ltr"><div class="gmail_default" style="font-size:large">​I have two XYZ Printing Da Vinci 1.0 3D printers, both of which were working fine until I upgraded to Windows 10.  It seems to be a common problem caused by the addition of 3D Builder, which changes the way the computer reads the 3D printer.  </div><div class="gmail_default" style="font-size:large">I tried uninstalling the software and drivers, as recommended in Soliforum.com, and installed updated software.  This allowed my computer to read the printer, but when I send a print I get a message saying that I don't have enough filament to complete the print.  I installed a brand new XYZ filament cartridge and still got the same message.</div><div class="gmail_default" style="font-size:large">I can provide more information.  I'm posting on the Classified section because I would like to find someone to troubleshoot my problem and get my 3d printers working again.  I am not a complete Luddite, but I can see their farm from where I stand.  I don't think I know enough to do the job myself.</div><div class="gmail_default" style="font-size:large">I don't care if I end up using Microsoft 3D Builder, XYZware factory software, Repetier (seems to be most popular), or other firmware as long as I can send a file and print it.  These are old, cheap 3D printers and an old, slow laptop, so I can't spend a lot of money on them.  I can, however, provide some cash and lots of free 3D printer time.  If you have been thinking of printing new game pieces or parts for a RepRap printer, this may be a good deal for you.</div><div class="gmail_default" style="font-size:large"><br></div><div class="gmail_default" style="font-size:large">Rick Nelson</div><div class="gmail_default" style="font-size:large"><a href="mailto:geezer.nelson@gmail.com">geezer.nelson@gmail.com</a></div><div class="gmail_default" style="font-size:large"><br></div></div>