[ML-General] Metal Sheet Break

[Chris Bero]

If you can break into Bob Jones High School, they have a largish one that
never gets used...

Chris Bero

On Tue, Nov 4, 2014 at 1:36 PM, Phillip Showers <phillip.showers at gmail.com>
wrote:

> Hi Kirk,
> There's a smallish one (~12") at the shop IIRC...
> Phil
>
> On Tue, Nov 4, 2014 at 1:32 PM, David Pemerton <david.pemerton at gmail.com>
> wrote:
>
>> what gauge of metal are you bending?
>>
>> On Tue, Nov 4, 2014 at 1:30 PM, Kirk D Mccann <kirk.mccann at gmail.com>
>> wrote:
>>
>>> Any idea where I can find a metal break for bending sheet metal?
>>>
>>> -Kirk
>>>
>>> _______________________________________________
>>> General mailing list
>>> General at lists.makerslocal.org
>>> http://lists.makerslocal.org/mailman/listinfo/general
>>>
>>
>>
>> _______________________________________________
>> General mailing list
>> General at lists.makerslocal.org
>> http://lists.makerslocal.org/mailman/listinfo/general
>>
>
>
> _______________________________________________
> General mailing list
> General at lists.makerslocal.org
> http://lists.makerslocal.org/mailman/listinfo/general
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.makerslocal.org/pipermail/general/attachments/20141104/efced9a3/attachment.html>