[ML-General] IMU units

[david]

Thanks, Matthew,   I downloaded that before I bought one to be sure it 
would work for my application.  Are you by chance playing with them, too?

David




On 04/22/15 18:08, matthew varian wrote:
> Here is the data sheet for it, it should get you up and going
> http://ae-bst.resource.bosch.com/media/products/dokumente/bno055/BST_BNO055_DS000_12~1.pdf 
> <http://ae-bst.resource.bosch.com/media/products/dokumente/bno055/BST_BNO055_DS000_12%7E1.pdf>
>
> Good luck!
>
> On Wed, Apr 22, 2015 at 6:02 PM, david <ainut at knology.net 
> <mailto:ainut at knology.net>> wrote:
>
>     Anyone playing with the Bosch BNO-055 units, with internal "sensor
>     fusion" already built-in?  I just received two of them and can't
>     wait to solder the pins so I can tinker!
>
>     Any comments about the device?  They're a bit less than $35 for a
>     Teensy 3.1 compatible board.  I plan to use them with a Beaglebone
>     Black.  They are 3.3V units and use I2C.
>
>     David Merchant
>
>
>     _______________________________________________
>     General mailing list
>     General at lists.makerslocal.org <mailto:General at lists.makerslocal.org>
>     http://lists.makerslocal.org/mailman/listinfo/general
>
>
>
>
> _______________________________________________
> General mailing list
> General at lists.makerslocal.org
> http://lists.makerslocal.org/mailman/listinfo/general

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.makerslocal.org/pipermail/general/attachments/20150422/3930dd11/attachment.html>