[ML-General] IMU units

[James Fluhler]

I had not heard of these before look pretty cool I may have to pick up some! If you find some success with these maybe toss up a quick tutorial sometime! 

James F.

> On Apr 22, 2015, at 7:02 PM, david <ainut at knology.net> wrote:
> 
> Thanks, Matthew,   I downloaded that before I bought one to be sure it would work for my application.  Are you by chance playing with them, too?
> 
> David
> 
> 
> 
> 
>> On 04/22/15 18:08, matthew varian wrote:
>> Here is the data sheet for it, it should get you up and going
>> http://ae-bst.resource.bosch.com/media/products/dokumente/bno055/BST_BNO055_DS000_12~1.pdf
>> 
>> Good luck!
>> 
>>> On Wed, Apr 22, 2015 at 6:02 PM, david <ainut at knology.net> wrote:
>>> Anyone playing with the Bosch BNO-055 units, with internal "sensor fusion" already built-in?  I just received two of them and can't wait to solder the pins so I can tinker!
>>> 
>>> Any comments about the device?  They're a bit less than $35 for a Teensy 3.1 compatible board.  I plan to use them with a Beaglebone Black.  They are 3.3V units and use I2C.
>>> 
>>> David Merchant
>>> 
>>> 
>>> _______________________________________________
>>> General mailing list
>>> General at lists.makerslocal.org
>>> http://lists.makerslocal.org/mailman/listinfo/general
>> 
>> 
>> 
>> _______________________________________________
>> General mailing list
>> General at lists.makerslocal.org
>> http://lists.makerslocal.org/mailman/listinfo/general
> 
> _______________________________________________
> General mailing list
> General at lists.makerslocal.org
> http://lists.makerslocal.org/mailman/listinfo/general
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.makerslocal.org/pipermail/general/attachments/20150422/3e5066a2/attachment.html>